topic Re: EERO 6 - Blink (Sync Module 2) in Full Fibre

EERO 6 - Blink (Sync Module 2)

AndyCurry76 — Wed, 10 Apr 2024 16:01:30 GMT

Recently changed ISP to Talk Talk and subsequently installed the Eero 6 Mesh system which is working perfectly fine.

However, I have been unable to link my Blink Camera System to the network . The error message I get is “most likely cause incorrect password”.

There appears to be several suggestions on the internet and I have tried all of the below:

- Triple checking password

- Factory reset on the Sync Module 2

- Temporarily turning off the 5ghz

- Turning on Legacy mode

None of which has worked?! I have no special characters in my password.

Hopefully someone can assist!

Re: EERO 6 - Blink (Sync Module 2)

Anonymous — Thu, 11 Apr 2024 05:56:47 GMT

Hi Andy,

Can I just confirm, does this device support Wifi 6? Does the device also have the latest software version?

Thanks

Michelle

Re: EERO 6 - Blink (Sync Module 2)

AndyCurry76 — Fri, 12 Apr 2024 06:37:30 GMT

Hi Michelle

It appears that BLINK does not support wifi 6!

Is there a workaround? I have tried turning off Legacy mode and 2.4 only but that didn’t work?

I have around 6 Blink Cameras and a Blink Door Bell.. I’d really like to get these operational.

thanks

Re: EERO 6 - Blink (Sync Module 2)

Chris-TalkTalk — Fri, 12 Apr 2024 08:18:28 GMT

Hi Andy,

Have you tried contacting Blink's support line, they may be able to help

Chris

Re: EERO 6 - Blink (Sync Module 2)

KeithFrench — Mon, 15 Apr 2024 10:01:39 GMT

On the Eero, you will need legacy mode on, otherwise it will never connect. I suspect that this IoT device will only work on the 2.4GHz band.

Re: EERO 6 - Blink (Sync Module 2)

KeithRan — Fri, 19 Apr 2024 09:07:11 GMT

I have two Blink Sync module 2 units running on Eero Pro 6 (Eero OS v 7.2.2-16). They work fine for me but didn't initially.

The solution was turn off power to the Sync modules. In the Eero 6 app under Discover/ eero labs make sure WPA3 is off. Under Settings/ Troubleshooting select 'My device is 2.4 Ghz only' and hit 'Temporarily Pause 5 Ghz'. You then have 10 minutes to turn on your Sync modules

Additional note: I renamed my Eero network and password to be the same as my previous router to avoid any config problems